NO SAMBA connection after software reset

[biosam]

good evening
after software reset for problem of lag, i loose SAMBA connection with my synology nas....how can risolve?
i have just installed ultimate firmware thank

ps sorry for bad english

[stl]

With a software reset you might lose part of the pre installed factory software, you should reinstall the firmware instead. What version you have?

[biosam]

Thank  for answer....i have 2.1.4

[bfrqrv]

Same here! I use SMB for years and now after updating from 2.1
0 to 2.1.4 the SMB search in mediaplayer and Kodi gives " no server" ES file explore does work.
Can someone confirm that SMB is correct im the new firmware?

[bfrqrv]

Nobody can make a quick test to see if SMB search browser works in mediaplayer on the newest version?

[kodiloaded]

Samba is working fine for me in CFW 2.1.4

Dirty Upgrades & Factory Resets are not recommended, Always, Always do a CLEAN INSTALL !

[bfrqrv]

Samba is working fine for me in CFW 2.1.4

Dirty Upgrades & Factory Resets are not recommended, Always, Always do a CLEAN INSTALL !

Can you poit me to that methode? I always see this everywhere:

1. Rename firmware update .zip (e.g. update_Q(...)Pro_(...)_HMD-1.0.8(...).zip) to update.zip.
2. Copy update.zip to the root of a USB pen drive.
3. Insert the USB pen drive into any USB port of the Q10/Q5Pro.
4. With the Q10/Q5Pro turned off, use a paper clip or pen to press and hold the the pinhole restore button on the back side of the Q10/Q5Pro.
5. While keeping the RESTORE/UPGRADE button pressed, turn on the Q10/Q5Pro.
6. The Q10/Q5Pro will show an Android logo and proceed to upgrade the firmware.
7. The box will auto-reboot when finished.
8. First boot can take 4-5 minutes.
9. Wait 15 minutes after first boot to allow system and apps to initialise.

[kodiloaded]

That is exactly how you do it !

[bfrqrv]

That is exactly how you do it !

Correct, so where is the dirty?

[kodiloaded]

Dirty upgrade is when you use the built in Updater in Settings/Upgrade

[bfrqrv]

Dirty upgrade is when you use the built in Updater in Settings/Upgrade

Ok thx but still no SMB servers found in the browser. It must be something local then.

[Mount81]

Are you sahring from a NAS or a Windows PC? See the FAQ Tread "Networking" section for possible solutions.

[condorbg]

I have the same problem on my Q5 Pro. Probably problem is in samba support. I try to search and receive " no servers " error. If I try to add local server I receive error: new server error. My pc is connected to this server also but with SMB3 protocol. Any one have ideas ?

[adam1411]

I have the same message "no server"with firmware 2.14

[adam1411]

I have also a Nvidia TV Shield and with that device i can connect with SMB samba!!!

So the problem is with the old Himedia Q10 and i tried different firmware and no server!!!!

So Futeko please solve this?