TLBB Once click Setup - OK to try?

[advb69]

Hi,

My box came with TLLB One Click Setup pre-installed.  However, when I started to run it, it advises that it is a test version and shouldn't be used.

If I were to run it, would a factory reset take the box back to its original state?  Or is it not even worth running TLLB One Click Setup?

Thanks!

[futeko.com]

TLBB one click setup is broken and shouldn't be run. If you did run it then results would be unpredictable and you might have to reinstall firmware.

[advb69]

Ah - I did start running it and then cancelled the process.  It is probably best then if I re-install the firmware just in case.

How do I do this?

I assume that I have to use the link to the firmware in an earlier post (http://www.mediafire.com/download/tw6jxstv9tly45d/OpenELEC-TLBB.V3b.arm-
6.0.0.zip) but I'm not clear what I need to do with the zip file.

Thanks.

[futeko.com]

Ah - I did start running it and then cancelled the process.  It is probably best then if I re-install the firmware just in case.

How do I do this?

I assume that I have to use the link to the firmware in an earlier post (http://www.mediafire.com/download/tw6jxstv9tly45d/OpenELEC-TLBB.V3b.arm-
6.0.0.zip) but I'm not clear what I need to do with the zip file.

Thanks.

Extract the contents of the zip to a micro-SD card (3 files). Power up the V3 (switch on back) with the micro-SD card inserted and and the restore button (under LAN port) on the back pressed.

[advb69]

Thank you.  That worked perfectly.