Thank you very much for the tip. I've just ordered the psu and I should receive it on friday. I'll let you  know if it solves the resetting problem.Kind regards Giacomo

     

Hi Mount81. I experienced a similar issue for 3 times with firmware 1.0.9. The rebooting phase could take several minutes instead of about 30 sec. After the long reboot my q10 had lost all my settings, google play account and apps as if a factory reset had been made. The himedia  wrapper was among the uninstalled apps too. Then I made a new install of firmware 1.09 with the paper clip method. After the third reset I decided to go back to firmware 1.08 . I've been using it for about 3 months and the strange delay in booting and reset has never happened again
Bye Giacomo.

Hi , I installed SPMC on my Q10 pro running Android 5 firmware version 1.08, so now I have both Kodi 16.1 and SPMC installed on it.
The wrapper works on kodi  but not on SPMC  ( when I play a movie in SPMC kodi internal player is used while in Kodi Himedia player).
Is very any way to use the wrapper for SPMC too?

Thank you very much
Giacomo

The sort of firmware reset that I talked about seems very similar to what is descibed in this other post:
http://www.futeko.com/newforum/index.php?topic=1580.msg12622#msg12622
Kind Regards
Giacomo

Hello, last week I loaded via OTA the last android 5 firmware.
Everything has worked fine for a couple of days than, last friday,  my Q10 crashed and I had to turn off the electric plug and restart again since the off button didn't work.
When it restarted it was as if a factory reset had been made: all  my kodi setup where lost  and also all the apps I had installed were lost. The wrapper app was missing too and I had to reinstall it downloading the apk from the link in this forum.
Since then the samba service has stopped working and my Q10 is not visibile in my home network.
If I go to settings I can turn it on and off ( and it says it has regularly started/stopped), but nothing changes in my home network.
What could I try to do to try to make it work again?
Thank you very much.
Giacomo

Hello, I still have a problem after running the patch ( I chose standard installation)
My Q10 pro has firmware 1.0.8 2016-10-12.193826 .  It has an external usb 3 hard disk (3TB) and an internal sata hard disk 4 TB. Both work correctly and  I can access them both with the file explorer  and as samba windows share with my windows pc as well. 

After the install if I select  the disk by uuid  folder I see them both and I also see their content, while if I select the disk-by-label  I see both labels (volume for the usb one and store4tb for the internal) but   the internal hard disk is seen as empty (no folders and no files are displayed).

Thank you very much.
Best regards
Giacomo

Hello , I got the same message yesterday when i tried to run the patch.
Giacomo