futeko.com FORUM

Product Support => HiMedia Q10 Pro, Q5 Pro => Topic started by: ccj30 on September 22, 2020, 10:33:42 PM

Title: Boot Q10 pro broken after wrong firmware update.
Post by: ccj30 on September 22, 2020, 10:33:42 PM

Hi,
I have try to made a firmware update last night.
But after a very long time 0,5 hour, no answer...
I have power off the Q10 pro. But now, the boot is broken.
One question:

Does a procedure exist to repare the boot or continue the update firmware, With PC or other?
Regards,
Ccj30.

Title: Re: Boot Q10 pro broken after wrong firmware update.
Post by: pcristi on September 22, 2020, 11:12:49 PM

First try to install v2.0.3, if not working read next message.
https://www.futeko.com/newforum/index.php?topic=4879.msg31703#msg31703
https://www.futeko.com/newforum/index.php?topic=1622.msg14469#msg14469

Title: Re: Boot Q10 pro broken after wrong firmware update.
Post by: ccj30 on September 23, 2020, 01:51:02 PM

Hi,
OK, i will try when it's possible...
Thanks a lot,
Ccj30...

Title: Re: Boot Q10 pro broken after wrong firmware update.
Post by: ccj30 on September 23, 2020, 10:45:06 PM

Hi,
It's OK for me, firmware installed after bridge the 2 pins.
I have installed the 2.1.4 version.
Just 1 little pb, the remote Control doesnt Work now...
Thanks a lot.
Ccj30.

Title: Re: Boot Q10 pro broken after wrong firmware update.
Post by: pcristi on September 24, 2020, 10:16:48 AM

Change IR remote battery then use phone camera to see if IR led are working.
If all OK the do check of all cable connection are OK inside of box after disassembly and assembly back.

Title: Re: Boot Q10 pro broken after wrong firmware update.
Post by: ccj30 on September 25, 2020, 05:42:16 PM

Hi,

OK, it's good. It was a bad connection.
All is allright now.
Thank you very much ...

Ccj30.