futeko.com FORUM
Product Support => HiMedia H8 => Topic started by: Napper1327 on September 27, 2017, 10:18:45 AM
-
Hi all
I'm using an H8 OctaCore - latest firmware, KODI 17 Krypton (or SPMC or PLEX).
It's getting media from my QNAP TS451 over CAT6 and going into a Yamaha RX-V583 HDMI.
I've set the audio out on the H8 to HDMI, KODI (and SPMC) system settings > Audio > Enable Passthrough
The amp is set to receive the signal as sent ('Straight' ie no DSP/Virtual surround). I've checked with the manufacturer and that's correct for receiving an Atmos signal using passthrough. the amp is configured correctly to output in the correct 5.1.2 setup
When I play any of the Dolby Digital theater test files (5.1 DD, TrueHD7.1, Lossless Atmos etc) the amp always detects the signal as PCM 2/0/---
What am I missing? Any help would be soooo appreciated, I'm going a bit mad trying to figure this out.
Thanks
N