futeko.com FORUM
Old Product Support => Venz V3 => Topic started by: advb69 on April 01, 2016, 01:56:51 PM
-
Hi,
My box came with TLLB One Click Setup pre-installed. However, when I started to run it, it advises that it is a test version and shouldn't be used.
If I were to run it, would a factory reset take the box back to its original state? Or is it not even worth running TLLB One Click Setup?
Thanks!
-
TLBB one click setup is broken and shouldn't be run. If you did run it then results would be unpredictable and you might have to reinstall firmware.
-
Ah - I did start running it and then cancelled the process. It is probably best then if I re-install the firmware just in case.
How do I do this?
I assume that I have to use the link to the firmware in an earlier post (http://www.mediafire.com/download/tw6jxstv9tly45d/OpenELEC-TLBB.V3b.arm-
6.0.0.zip) but I'm not clear what I need to do with the zip file.
Thanks.
-
Ah - I did start running it and then cancelled the process. It is probably best then if I re-install the firmware just in case.
How do I do this?
I assume that I have to use the link to the firmware in an earlier post (http://www.mediafire.com/download/tw6jxstv9tly45d/OpenELEC-TLBB.V3b.arm-
6.0.0.zip) but I'm not clear what I need to do with the zip file.
Thanks.
Extract the contents of the zip to a micro-SD card (3 files). Power up the V3 (switch on back) with the micro-SD card inserted and and the restore button (under LAN port) on the back pressed.
-
Thank you. That worked perfectly.